Removing The Mainboard - JVC KD-SH707 Service Manual

Removing the main board
Prior to performing the following procedures, remove
the top chassis and the motor bracket.
1. Disconnect the flexible wire from connector CN701
and CN702 on the main board respectively.
2. Move the front bracket backward until it stops.
3. Remove the four screws K
brackets (L) and (R). Move the right and arm lefter
brackets from the rod gear.
4. Remove the rod gear.
5. Remove the screw M attaching the rear panel to the
bottom cover on the back of the body.
(See Fig.12 to 16)
attaching the arm
L
Main board
K
Arm
brackets (L)
K
CN701 CN702
Arm brackets (L)
Arm brackets (R)
Rod gear
Rear panel
L
Arm
brackets (R)
Rod gear
Fig.12
Main board
Fig.13
M
Bottom cover
Fig.14
KD-SH707
K
1-7