Repairs- After Sales Service - John Lewis JLBIWD 1403 Instruction Manual

Drill four fixing holes see Fig. G
600-605 mm
95 mm
Front edge
50 mm
Top view
G
Position the base into the recess with its front edge as
far forward as the adjoining plinth line will allow.
The reason for placing the base in this position
is to allow a small strip of beading to be fitted in
front of the appliance feet.
Fix the base firmly to the floor using four appropriate
countersunk screws (see Fig. H).
With the appliance installed adjust all four feet ensuring
the machine is stable, and a clearance of approximately
Repairs - After sales service
In the event of your appliance requiring service, or if
you wish to purchase spare parts, please contact our
extended warranty administrators by telephoning:
0870 01 07887
They will give you details for your local Service Force
Centre. Service Force are the appointed national
appliance repair agents responsible for warranty repairs
to this appliance.
Before calling out an engineer, please ensure you have
read the details under the heading "Something Not
Working".
When you contact the Service Force Centre you will
need to give the following details:
1. Your name, address and post code
2. Your telephone number
3. Clear and concise details of fault
4. The purchase date and found on your receipt.
5. The model and serial number of the appliance
(found on the rating plate - see picture)
So that you always have these numbers to hand, we
recommend you to make a note of them here.
Model................................................................................................
PNC...................................................................................................
SN.......................................................................................................
490 mm
27
5 mm is left between the top of the machine and the
underside of the worktop.
Hardwood strip
5 X 25 X 605
5 mm x 25 mm
600-605
H
A final check for stability should be carried out with the
machine on spin with a load, this will identify the need
for any further fine adjustment to the feet.
A strip of beading approximately 605 mm W, x 5 mm
H, x 25 mm D must be screwed down into the base
directly in front of the machine's feet, this will provide
additional security.
If required an additional door magnet, part number
1242394-00/3 and disc, part number 1242393-00/5 are
available from spare parts.
Your washer dryer is covered by a 3 year parts
and labour guarantee (see separate details given
at point of sale). Please retain your purchase
receipt safely for the service .
Mod. ..........
Prod. No. ...........
Ser. No. .........
P0042 BD
Please note that a valid purchase receipt is
required for in-guarantee service calls.
Spare parts
An authorised service engineer should service this
product, and only genuine spare parts should be used.
Under no circumstances should you attempt to repair
the machine yourself. Repairs carried out by
inexperienced persons may cause injury or serious
malfunctioning. Contact your local Service Force
Centre.
490