Input Jack - Peavey PV 115 D Operating Manual

SPEAKER OUT JACK
4
This jack allows a full-range passive (unpowered) speaker to be connected to the PV
amp, as long as it has an impedance rating no lower than 8 ohms, and is of similar sensitivity as the PV115D
speaker system. Ideally, this speaker would be the passive model PV115, however, other 8-ohm passive
full-range speakers with a nominal sensitivity of around 95 dB can be used. This additional speaker system
can help increase coverage of the venue. The volume level of this added speaker is controlled at the same
time as the volume of the PV115D, thus the need to use a speaker system with a similar sensitivity.
It can also be used to drive an 8-ohm impedance non-powered subwoofer with a built-in high-frequency
roll-off, such as the PV-118 Sub.
T O p p a n e l

INPUT JACK

5
The line level input is of the medium impedance balanced type. Jack (5) is a combo female XLR and 1/4"
TRS connector, and can be supplied a balanced or unbalanced input signal.
LEVEL
6
Controls the gain (volume) of the Input (5) of the powered speaker system.
CONTOUR SWITCH
7
The Contour switch provides a mild boost at the frequency extremes, so that low level playback can be
more pleasing. Do not use the Contour switch when playing sound at loud levels, as the boost is not
needed then.
LINK OUT
9
Link Out is a 1/4" pre-level send intended for the use of linking multiple PV
the Link Out would connect to the 1/4" connections of the MIC/LINE (5) input of the next PV
line of PV speakers. Individual speakers can be adjusted by their own Level control(6). This output can
also be used to drive a nearby powered subwoofer, such as the PV
control to a level that matches that of the output of the PV
POWER/CLIP LED
9
Illuminates GREEN when the electronics receive power (when the Power switch (3) is On). Illuminates RED
when amplifier clipping is occurring.
5 6 7 8
115D's in a line. In that case,
®
118D Sub. Set the PV
®
115D.
®
115D internal power
®
9
115D in the
®
118D Sub level
®