Rear Panel - Samsung MX-F630 User Manual

Rear Panel

MX-F730 only
1. 2.0 CH Speaker Connector Terminals
The speaker connector terminals are located on
the rear of the system.
1. To achieve the correct sound quality, insert the
speaker connector cables identified below into
the correct speaker terminals on the back of
the system.
• L eft speaker (marked L).
• R ight speaker (marked R).
2. ONLY FOR SERVICE
• T his jack is for service only. Please do not use.
3. AUX IN Terminals
1. Use an Audio Cable (not supplied) to connect
AUX IN on the product to Audio Out on an
external analog component.
• B e sure to match connector colors.
• I f the external analog component has only one
Audio Out jack, connect to either the left or
right terminal.
• Press the TUNER/AUX button to select the
AUX input.
• When the unit is in AUX mode, if none of the
buttons are pushed for more than 8 hours, the
power will automatically turn off.
6
English
1
2
3
4
4
5
4. FM/AM(optional) Antenna Connector Terminal
The position of FM antenna connector terminal may
differ depending on your region.
This product may not support the AM function
depending on your region.
☛
If this product does not receive AM broadcasts.
Connect the FM antenna:
1. Connect the FM antenna (optional) to the FM
Antenna jack.
2. Slowly move the antenna wire until you find a
location where reception is good, then fasten it to
a wall or other rigid surface.
3. If reception is poor, you may need to install an out-
door antenna. To do so, connect an outdoor FM
antenna to the FM socket on the rear of the system
using a 75Ω coaxial cable (not supplied).
☛
If this product can receive AM broadcasts. (Optional)
Connect the FM/AM antenna:
1. Plug the connector on the FM/AM antenna
(optional) into the FM/AM terminal on the rear of
the system.
5. Voltage Selector (MX-F730 only (Optional))
Check the position of the voltage selector on the rear of
the system(optional).
This product may not support the Voltage Selector
function depending on your region.