Adjustment Of The Finisher (Mj-1022) - Toshiba e-studio200l Service Handbook

3.12 Adjustment of the Finisher (MJ-1022)

3.12.1 Adjusting the jogging plate width
<Procedure>
(1) Remove the right inner cover and the rear cover.
(2) Adjust the front jogging plate to the home
position.
• Set SW1 on the finisher controller PC
board as shown in  P.3-85 "Fig. 3-109
".
• Press SW2 twice on the finisher controller
PC board.
- The front jogging plate moves to the
home position.
(3) Adjust the rear jogging plate to the home
position.
• Set SW1 on the finisher controller PC
board as shown in  P.3-85 "Fig. 3-110
".
• Press SW2 twice on the finisher controller
PC board.
- The rear jogging plate moves to the
home position.
(4) Measure the jogging width (standard at 317 mm).
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
ON
1 2 3 4
Fig. 3-109
ON
1 2 3 4
Fig. 3-110
Rear jogging plate
home position
Jogging width
317mm
Fig. 3-111
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
3 - 85
5 6 7 8
5 6 7 8
Front jogging plate
home position
ADJUSTMENT
3