Panasonic TH-65PB1E Operating Instructions Manual page 14

Connections
Example of Network Connection (Wired LAN)
COMPUTER
Ferrite core
(supplied)
Hub or broadband router
Notes:
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use "category 5" LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.
Connecting Wireless Module (Wireless LAN)
To use the wireless function, the wireless module (ET-WM200E) (sold separately) is necessary.
When connecting the wireless module to the
display, remove the protective ¿ lm and cap.
Connecting procedure
Hold the wireless module with its LED on the near
side and connect it to the wireless module connection
terminal.
Note:
Do not connect any other device than the wireless
module (ET-WM200E).
When using the electronic pen
Using the electronic pen with the wireless module
(ET-WM200E) connected may result in malfunction of
the electronic pen due to radio wave interference as
an example. In that case, set "Wireless Lan" to "Off"
before using the electronic pen. (refer to "Operating
Instructions, Network Operations")
14
Less
than
10 cm
LAN cable
(not supplied)
Ferrite core
(supplied)
Installing the Ferrite core
Less
than
10 cm
Pull back the tabs
(in two places)
Display (main unit, rear)
Open
Wind the cable Press the cable
twice through and close
(8Ω,20W[10W+10W])
ET-WM200
LED