Maintenance - DeWalt DW293 Original Instructions Manual

Your D WALT tool is double insulated in
e
accordance with EN 60745; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
e
using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor size
is 1 mm ; the maximum length is 30 m.
2
When using a cable reel, always unwind the cable
completely.
WARNING: Always wait until the motor
has come to a complete standstill
before changing the direction of
rotation.
opeRAtion
instructions for use
WARNING:
Always observe the safety instructions
and applicable regulations.
WARNING: To reduce the risk of
serious personal injury, turn tool off
and disconnect tool from power
source before making any
adjustments or removing/installing
attachments or accessories.
Screwdriving or Nutsetting (fig. A)
● Select the appropriate socket for the screw or
nut to be driven.
● Select forward or reverse rotation as described
above.
● Hold the tool in line with the fastener.
proper Hand position (fig. A, B)
WARNING: To reduce the risk of
serious personal injury, AlWAys use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, AlWAys hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the main
handle (4), as shown.
Switching On and Off (fig. A)
● To run the tool, press the on/off switch (1).
● To stop the tool, release the switch.

MAintenAnce

Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, switch off and disconnect the
tool from the power source before
installing and removing accessories,
before adjusting or changing set-ups
or when making repairs. Be sure the
tool is switched off. An accidental
start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often
as dirt is seen collecting in and around
the air vents. Wear approved eye
protection and approved dust mask
when performing this procedure.
WARNING: Never use solvents or other
harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
e n g l i s h
5