Installation Overview - Russound XSource Installation Manual

INSTALLATION OVERVIEW

The XSource can be rack-mounted, table-mounted or wall-
mounted. You can connect multiple XSource media players
by using the integrated slide connectors as shown. For wall-
mount, use the mounting holes on the bottom of the unit.
See diagrams below.
Important Considerations
1. Disconnect the power cord before making any wiring
connections to the XSource.
2. Verify that all connections and polarity are correct.
Rack-mount - Slide Lock System
You can connect multiple XSource media players by
using the integrated slide connectors as shown.
Table-mount
For table-mount use the
rubber feet (included)
6
3. Keep all power cords away from all signal cables to
prevent humming caused by induced noise.
4. Label wires appropriately, on both ends of the wire run.
5. Avoid running speaker wires or signal cables close to
house electrical wiring for any distance. If you have to run
them parallel, make sure to space the wires at least two feet
from the AC line. If you need to cross an AC line it should be
at a 90° angle.
Slide connectors
4 Non-marking
adhesive rubber feet
Russound XSource Installation Guide
Wall-mount
For wall-mount use the mounting
holes on the bottom of the unit.
Holes for wall-mount.