Short Instructions - Cobra G100 User Manual

5 - SHORT INSTRUCTIONS.

5.1 - Arming.
• When radiocontrol button "A" is pressed, the doors lock
(if the vehicle is equipped with a centralized locking
system).
• The direction lights flash twice.
• The buzzer emits two acoustic signals (if enabled).
• The LED lights up and stays on for 25 s, then flashes.
• The protection functions activate after 25 s.
5.2 - Silent arming.
For temporary elimination of the buzzer signal when arming the system,
press radiocontrol button "A" before turning off the ignition. The next
time it is armed, the buzzer will start working again.
5.3 - Disarming.
• When radiocontrol button "B" is pressed, the doors
unlock.
• The direction lights flash once.
• The buzzer emits one acoustic signal (if enabled).
• The protection functions are immediately deactivated.
• The LED is switched off.
G100 USER AND FITTING INSTRUCTIONS
06DE2245D OK.pmd
B
A
B
A
GB
15
5.4 - Interrupting an alarm during the warning - signal cycle.
While the system is sounding the alarm it is possible to
deactive the siren and flashing lights by pressing radio
control button "B" once (one press). This operation
interrupts the alarm cycle, but the system stays armed.
To deactivate the system completely, it is necessary to
disarm it by pressing radiocontrol button "B" again (two
presses).
5.5 - Deactivating the ultrasonic volumetric sensor.
If you wish to activate the protection system with the
windows left open or when a passenger will be staying
inside the passenger compartment, it is possible to
deactivate the volumetric sensor so that it will not generate
any alarms.
09/09/2008, 10.06
B
A
B
A
15