Table of Contents
Advertisement
4. Confirm that the reading of the laser power meter is within the specified range. If it is not within the specified range,
adjust by turning VR1. Refer to
Specified range (read power): 600 µ µ µ µ W or lower
Caution:
Proceeding on to the subsequent adjustment procedure with the read power exceeding 600 µ µ µ µ W will result in
damage to the optical pickup.
5. Press "2" on the remote control transmitter.
"WRITE LASER" will be displayed to indicate the write power adjustment mode.
6. Confirm that the reading of the laser power meter is within the specified range. If it is not within the specified range,
adjust by turning VR1. Refer to
Specified range (write power): 4.8 mW±0.1 mW
Caution:
Do not allow the write power to even momentarily reach or exceed 5.5 mW. Doing so will result in damage to
Fig. 17-4.
Fig. 17-5.
Fig. 17-5.
Fig. 17-5.
43
Advertisement
Table of Contents
