Table of Contents
Advertisement
HARDWARE CONTENTS
Pack
AA
1/4-in. x 15-mm Truss Head Screw With Locking Washer
BB
1/4-in. x 12-mm Truss Head Screw With Locking
Steel)
CC
5/32. x10mm Truss Head Screw With Locking
DD
AA
BB
PREPARATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare
parts with package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 50 minutes
Tools Required for Assembly:
Phillips Screwdriver (not included) and Wrench (not included)
Note: The right and left sides of the grill are designated as if you are standing and facing the grill.
ASSEMBLY INSTRUCTIONS
1. Swivel Caster Assembly
Mount the caster onto the bottom panel (A) using sixteen
1/4-in.
x15-mm truss head screw
and sixteen 1/4-in. flat washers
Position the swivel caster with brake (C) under the left
rear of the cart bottom (A), and position the swivel caster
(D) under left front as shown in Fig. 1.
Position the two stationary casters (B) should be positioned
under the right side.
NOTE: Turn over the bottom panel to mount the cast.
Description
1/4-in. Flat
Washer(PDC)
CC
DD
with
locking washers
(DD).
(PDC)
Washer(Stainless
Washer(Stainless Steel)
A
(AA)
1/4-in.x15-mm truss head screw with locking
washers (AA) 16 x
1/4-in. flat washers (DD) 16 x
6
Required
Extra
for
hardware
assembly
22
2
18
2
2
1
22
2
Fig. 1
C
D
B
Total
24 pcs.
20 pcs.
3 pcs.
24 pcs.
AA
DD
Advertisement
Table of Contents
