Area Setting; Setting The Installation Position; I-See Control Operation; Area - Mitsubishi Electric MSZ-FD25VA Operating Instructions Manual

P
REPARATION
BEFORE OPERATION

Setting the installation position

Be sure to set the slide switch inside the remote controller in accordance with
the installed position of the indoor unit.
Installation position:
Left: Distance to objects (wall, cabinet, etc.) is less than 50 cm to the left
Center: Distance to objects (wall, cabinet, etc.) is more than 50 cm to the left
and right
Right: Distance to objects (wall, cabinet, etc.) is less than 50 cm to the right
(Left) (Center) (Right)

Area

Left
Slide switch
Remote controller
display
Press during COOL mode to activate i-see control
operation.
• Press gently using a thin stick.
• lights. (Operation display section)
Press again to release i-see control operation.

i-see control operation

The sensors constantly measure the room and
fl oor/wall temperature to automatically adjust to
the set temperature by estimating the tempera-
ture actually perceived by a person inside the
room ("sensible temperature").
i-see sensor
When the AREA setting is not activated, the sensing range of the move eye sensor
differs depending on the installation location of the air conditioner.
Installation position Left
Sensing range
Note:
Do not touch the i-see sensor. This may cause malfunction of the i-see sensor.
Slide switch
Center Right
Room
Floor/wall
temperature
temperature
30.9%
43.7%
Humidity
20.7%
Center Right
A
REA SETTING
Press to select AREA. Each press changes
AREA in the following order:
(AUTO) (Left)
• The i-see control operation has to be active to select AREA.
• Horizontal airflow direction
set.
*1 Horizontal airflow direction set by
Press until "Cancel" is selected to release AREA
setting.
• Pressing also releases AREA setting.
Area
(AUTO) ....The i-see sensor detects temperature disparities, efficiently
cooling the whole room.
In COOL mode:
Daytime
Warm area
(LEFT) / (RIGHT)
Select the desired area to be air conditioned.

Indoor unit display

Horizontal airfl ow direction:
Left Center or Swing
Cancel
(Right) *1
cannot be selected when AREA is
. Page 6
Nighttime
Cold area
Right
Lighted Not ligted
En-4