Samsung GT-i9001 Service Manual page 27

7. Level 2 Repair
7-2. Disassembly
1 Unscrew screws on the rear
Unscrew 7 screws on the rear using a screw driver.
screw torque : 1.2 ~ 1.4 kgf.cm
3
Detach the Power Key FPCB
Detach the power key FPCB, that is stick to the bracket
by a double-sided tape, using tweezers. Make sure to
remove all remaining tape on the bracket.
This Document can not be used without Samsung's authorization
SAMSUNG Proprietary-Contents may change without notice
2
Unhook the rear using a disassembly knife
to remove the rear cover
Be careful not to damage the rear cover when unhooking
it.
4
Disconnect connectors from the Main PBA
Disconnect LCD Connector,Receiver Connector, Sub-touch
Key Connector and Antenna cable from the Main PBA
7-4