Part 2 - Prepare The Water Heater; What's In The Box; Locating The Water Heater - Westinghouse WEC080C2X030 Use And Care Manual

4

Part 2 - Prepare the Water Heater

Remove all sides of the shipping crate to allow the heater to be
moved into its installation location.
COLD WEATHER HANDLING - If the water heater has been
stored in a very cold location (BELOW 0
handle with care until the components come to room
temperature. Failure to do so could result in damage to the
water heater.
A. What's in the Box
Components included with the water heater:
• Drain Valve
• Temperature and Pressure Relief Valve
• Insulation
• Cover with Screws
• Hot Water Outlet
• Dip Tube
• Use and Care Manual and Warranty
NOTE: Some components may ship factory installed.
B. Locating the Water Heater
Locate the water heater where any leakage from the relief valve,
related piping, tank, or connections will not result in damage
to surrounding areas or lower floors of the building. The water
heater should be located near a floor drain or installed in a drain
pan. Leakage damages ARE NOT covered by warranty.
This water heater is certified for indoor use only. DO NOT
INSTALL OUTDOORS. Outdoor installations ARE NOT covered
by warranty. Failure to install the water heater indoors could
result in property damage, severe personal injury, or death.
This water heater must be installed upright in the vertical
position as described in this manual. DO NOT attempt to install
this water heater in any other orientation. Doing so will result
in improper water heater operation and property damage, and
could result in serious personal injury or death.
1. Installation Area (Mechanical Room) Operating Conditions
• Ensure ambient temperatures are higher than 32
o
and lower than 104
• Avoid continuously high levels of humidity
• Never close existing ventilation openings
NOTE: When installing in a zero clearance location, it may
not be possible to read or view some product labeling. It is
recommended to make note of the water heater model and
serial number.
The service life of the water heater's exposed metallic surfaces,
such as the junction box, is directly influenced by proximity
to damp and salty marine environments. In such areas higher
concentration levels of chlorides from sea spray coupled with
relative humidity can lead to degradation of water heater
components.
whl-035 Rev. 4.5.16
o F) before installation,
o
F / 40 C
Incorrect operating conditions can lead to damage to the
heating system and put safe operation at risk. Ensure that the
installation location adheres to the information included in
this manual. Failure to do so could result in property damage,
serious personal injury, or death. Failure of the water heater
or components due to incorrect operating conditions IS NOT
covered by product warranty.
2. Choose a location for the water heater as centralized to the
piping and electrical system as possible. Also, locate the water
heater and domestic water piping where it will not be exposed
to freezing temperatures. All piping should be insulated.
Additionally, place the water heater so that the drain, controls,
and inlets/outlets are easily accessible.
Figure 1 - Recommended Service Clearances - NOTE: Overhead
View Not Representative of All Models
NOTE: To save on heating costs and improve energy efficiency
keep the distance between the water heater and fixtures to
a minimum to reduce heat loss from excess piping and keep
friction loss at a minimum. Ensure all water heater piping is
properly insulated to minimize heat loss.
NOTE: If you do not provide the minimum clearances shown
in Figure 1, it might not be possible to service the water heater
without removing it from the space.
o o
F / 0 C
NOTE: A combustible door or removable panel is acceptable
front clearance.