Panasonic KX-T7730 Quick Reference Manual page 9

Location of Controls
PROGRAM: Used to enter and exit the
1
programming mode.
CONF (Conference): Used to establish a
2
multiple party conversation.
INTERCOM: Used to make or receive
3
intercom calls.
FWD/DND (Call Forwarding/Do Not
4
Disturb): Used to perform Call Forwarding
or Do Not Disturb.
FLASH/RECALL: Used to disconnect the
5
current call and make another call without
hanging up.
AUTO ANS (Auto Answer)
6
(KX-T7730): Used to receive an
incoming call in the hands-free mode.
MUTE (KX-T7730): Used to mute the
microphone during a conversation.
VOICE CALL (KX-T7750): Used to
monitor an intercom call automatically.
AUTO DIAL/STORE: Used for speed
7
dialling or storing program changes.
TRANSFER: Used to transfer a call to
8
another party.
REDIAL (ordinarily): Used to redial.
9
HOLD: Used to place a call on hold.
10
SP-PHONE (Speaker Phone)
11
(KX-T7730): Used for the
handsfree operation.
MONITOR (KX-T7750): Used for
handsfree dialling. You can monitor the
party's voice handsfree.
Navigator Key (KX-T7730): Used to
12
adjust the volume and the display contrast
or select desired items for each function.
Volume Key (KX-T7750): Used to
adjust the volume.
Flexible Outside (CO) Line Button:
13
Used to make or receive an outside call.
Pressing this button seizes an idle outside
line automatically. (Button assignment is
required.) Also used as the desired
function buttons. (Button assignment is
required.)
PAUSE: Used to insert a pause during
14
dialling.
MESSAGE: Used to leave a message
15
waiting indication or call back the party
who left the message waiting indication.
Message/Ringer Lamp: The Message/
16
Ringer lamp informs you visually that you
have a message or a call.
• When you receive a call, the lamp flashes
depending on the ringing pattern. When
someone has left you a message, the
lamp is lit continuously.
• When the ringing pattern is set to Single
(Slow flash), Double (Moderate flash), or
Triple (Rapid flash) in your PBX, the lamp
flashes. When the other ringing patterns
are set in your PBX, the lamp may not
flash. (e.g., S-Double, Call Waiting
Tone1).
– 9 –