Installing The Chargepak B1; Technical Specifications - PURE Evoke D2 Owner's Manual

Appendix

Installing the ChargePAK B1

Technical specifications

Radio:
Digital and FM, UK products receive DAB and FM;
non-UK products receive DAB/DAB+/DMB-Radio/
FM depending on region.
Audio:
1.6W RMS. Full-range 3" drive unit.
Input Connectors:
5.5V DC power adaptor socket (230V supplied), Mini
USB connector for product updates, 3.5mm Line-in
for auxiliary devices
Output Connectors:
3.5mm stereo headphone socket.
5.5V DC
1. Switch Evoke off and disconnect from the mains
power supply.
2. Open the battery compartment.
3. Insert the ChargePAK connector plug into the
socket in the compartment. Line up the ridges
on the plug with the slots in the socket to ensure
correct orientation. Do not force the plug.
4. Insert ChargePAK into the battery compartment,
logo side out.
5. Replace the battery cover and connect Evoke to
the mains.
6. ChargePAK will begin charging.
Note: If you are charging ChargePAK for the first
time or after an extended period of inactivity it is
recommended that it is charged for around 24
hours to ensure full battery power. If ChargePAK
is flat there may be a slight delay before the
battery charging indicator is displayed.
Power:
230V AC to 5.5V (1.0A) DC external power adapter
optional ChargePAK B1.
Power Consumption:
Standby: 0.7W, Active: 1.9W.
Dimensions:
115 mm wide x 180 mm high x 120 mm deep
Approvals:
CE marked. Compliant with the EMC and Low
Voltage Directives (2004/108/EC and 2006/95/
EC) ETSI EN 300 401 compliant.
Australian C-Tick N1600 and Electrical Safety.
EN
15