Engine Running Behavior; Rewind Starter; Storing The Machine - Stihl MS 210 Instruction Manual

Engine Running Behavior

If engine running behavior is
unsatisfactory even though the air filter
is clean and the carburetor is properly
adjusted, the cause may be the muffler.
Have the muffler checked for
contamination (carbonization) by your
servicing dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C

Rewind Starter

To help prolong the wear life of the
starter rope, observe the following
points:
Pull the starter rope only in the
N
direction specified.
Do not pull the rope over the edge of
N
the guide bushing.
Do not pull out the rope more than
N
specified.
Do not allow the starter grip to snap
N
back, guide it back into the housing
slowly – see chapter on "Starting /
Stopping the Engine."
Have a damaged starter rope replaced
by your dealer before it breaks
completely. STIHL recommends that
you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.

Storing the Machine

For periods of 3 months or longer
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Remove the saw chain and guide
N
bar, clean them and spray with
corrosion inhibiting oil.
Thoroughly clean the machine – pay
N
special attention to the cylinder fins
and air filter.
If you use a biological chain and bar
N
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
Store the machine in a dry, high or
N
locked location, out of the reach of
children and other unauthorized
persons.
English
37