United Mounting The Microphone...9 States. External Antenna .......10 This manual is published by Ericsson Inc., without any warranty. Attaching The Antenna Cable Improvements and changes to this manual necessitated by typo- To The Holder ......11...
The VEHICLE HANDSFREE INSTALL WHAT’S IN YOUR PACKAGE Package allows a portable radio to be The package includes the following: used in a vehicle. The radio operates as usual in the handsfree unit, except that it • Connection box uses an external microphone and speaker, and its internal microphone and earpiece •...
cables do not interfere with movement INSTALLATION in the vehicle. MOUNTING THE CONNECTION BOX 2. Use the mounting holes in the unit as a template to mark the holes. Before The connection box links all parts of you drill: avoid damaging the vehicle the HANDSFREE unit and connects them by checking for hidden parts below the to the vehicle’s power.
WIRING THE CONNECTION BOX TO THE VEHICLE’S BATTERY 1. Connect the fuse holder to the bat- tery with the red wire and washer connector. 2. Connect the black wire of the bat- tery cable to ground with a washer connector. 3.
3. Push the holder onto the mounting MOUNTING THE HANDSFREE HOLDER bracket. Fasten the holder and mounting bracket together with the long screw in the Follow the steps below to attach your package. The screw goes through the hole holder in either a stationary or swivel in the swivel ball inside the mounting com- mount.
4. Adjust the swivel tension using the about 8-12 inches from the driver’s face Phillips screw at the top of the plate and place a call. Do not point the cavity inside the holder. Snap the cover speaker toward the microphone. If you plate back into place.
4. Plug the speaker into the jack on the 2. Before mounting the microphone, plug connection box under the speaker it into the connection box, place it icon. where you plan to mount it, and place a call. If you hear squealing or howl- ing during the call, move the micro- phone.
4. Attach the TNC connector on the an- EXTERNAL ANTENNA tenna cable to the connector on the An external antenna greatly improves external antenna cable. portable’s performance NOTE: Do not install the antenna cable Handsfree Unit. To connect the holder to without installing an external antenna.
TROUBLESHOOTING RADIO PROBLEM PROBABLE CAUSE REMEDY The LED does not light The holder is not receiving Check the power connec- when the vehicle power is power, or vehicle power tions and fuse. Be sure supplied. polarity is reversed. the phone battery is charged.
Page 12
Ericsson Inc. Private Radio Systems Mountain View Road Lynchburg, Virginia 24502 AE/LZT 123 1874 R1A 1-800-528-7711 (Outside USA, 804-528-7711) Printed in U.S.A.