Biostar NF560-A2G Setup Manual page 89

NF560-A2G/NF520-A2G
Timing Mode
This item allows you to choose to manually or automatically regulate the DDR
Timing.
The Choices: Auto (default), MaxMemClk.
Memory Clock Value OR Limi
The Choices: DDR 400 (default), DDR 533, DDR 667, DDR 800.
DQS Training Control
The Choices: Perform DQS, Skip DQS (default).
CKE base power down mode
The Choices: Disabled (default), Enabled.
CKE based power down
The Choices: Per Channel (default), Per CS.
Memclock tri-stating
The Choices: Disabled (default), Enabled.
Memory Hole Remapping
The Choices: Enabled (default), Disabled.
Auto Optimize Bottom IO
The Choices: Enabled (default), Disabled.
Bottom of [31:24] IO space
The Choices: C0 (default); Min=0000, Max=00FF, key in a HEX number.
CAS Latency
The CAS Latency (tCL) is the time (in number of clock cycles) that elapses
after the memory controller sends a request to read a memory location and
before the data is sent to the module's output pins.
The Choices: Auto (default), 2.0, 3.0, 4.0, 5.0, 6.0.
DRAM Command Mode
This item allows you to choose the DRAM command mode.
The Choices: Auto (default), 1T, 2T.
35