Get Started; Prepare The Remote Control; Connect Power - Philips AZ700T User Manual

3 Get started

Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of your apparatus. The
model number and serial number are on the
bottom of your apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

For first-time use:
Remove the protective tab to activate the
remote control battery.
To replace the exhausted battery:
1
Remove the screw.
2
Open the battery compartment and insert
one CR2025 battery with correct polarity
(+/-) as indicated.
3
Close the battery compartment.
4
Tighten the screw.

Connect power

The unit can be powered by either AC power
or batteries.
Option 1: AC power
Warning
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or the underside of the unit.
•
Risk of electric shock! When you disconnect the AC
power, always pull the plug from the socket. Never pull
the cord.
Connect the AC power cord to:
• the AC~ MAINS socket on the unit.
• the wall socket.
Tip
•
To save energy, turn the unit off after use.
CR2025
EN 7