Serviceable Components Of The Main Sub-Assemblies - Motorola APX 5000 Service Manual

Sec 1: 8-20
8.7.9 Removal of the Control Top Assembly (F)
i. Use a Torx Plus IP8 bit to remove the two Control Top Screws (44). See
NOTE: Ensure the Control Top flex is disconnected from the VOCON Board (D) to prevent
Control Top Screws (44)
ii. Gently separate the Control Top Assembly (F) from the Main Chassis Assembly (E).
NOTE: Place the Control Top Assembly (F) and the remaining Main Chassis Assembly (E)
8.8

Serviceable Components of the Main Sub-Assemblies

8.8.1 Servicing Main Chassis Assembly (E)
Universal Connector Insert (17)
NOTE: For assembly, ensure the key feature
Figure 8-29. Serviceable Components – Main Chassis Assembly
Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies
damage to the flex or connector.
Figure 8-28. Remove Control Top Assembly
on an ESD safe surface free from debris.
O-Ring (16)
RF Coax Cable (20)
is aligned as shown.
Screws (44)
Chassis Ground Contact (18)
Coin Cell Pad (19)
Control Top Assembly (F)
Main Seal (50)
Figure 8-28.