Color Temp Adj Menu; Overview - Sony Trinitron BVM-A32E1WU Operation Manual

[A3] COPY FROM... menu
Copy picture adjustment preset data.
PRESET VALUE...: Copy other data in the monitor.
k[A31]
OTHER MONITOR...: Copy data from another
monitor. k[A32]
MEMORY STICK...: Copy data from a file in the
"Memory Stick". k[A33]
Note
Matrix data is not copied.
[A31] PRESET VALUE... menu
Copy data from another channel or common data.
Select one from among PRESET1, PRESET2, PRESET3,
PRESET4 and PRESET5.
[A32] OTHER MONITOR... menu
Assign the ID No. of the source monitor.
MONITOR ID...: Enter the ID No. of the monitor.
k[A321]
When the NETWORK switch is set to PEER TO PEER,
this is not selectable.
[A321] OTHER MONITOR menu
Copy data from another selected monitor.
Select one from among PRESET1, PRESET2, PRESET3,
PRESET4 and PRESET5.
[A33] MEMORY STICK... menu
Select a file in the source "Memory Stick". k[A331]
[A331] MEMORY STICK menu
Copy data in the selected file.
Select one from among PRESET1, PRESET2, PRESET3,
PRESET4 and PRESET5.
[B] Adjusting the Color
Temperature – COLOR
TEMP ADJ Menu

Overview

The color temperature is adjusted.
Use the factory setting value or the adjusted value as a base
value to shorten the adjustment time.
• Selecting the preset data to be adjusted (PRESET
VALUE menu)
• Knob adjustment (MANUAL... menu)
You can adjust the bias and gain with the MANUAL
knobs.
• Automatic adjustment (AUTO... menu)
You can use the following probes for automatic adjustment
of color temperature. Except for the Sony BKM-14L, a
cable is required to connect the color analyzer to the
monitor.
Manufacturer
SONY
KONICA MINOLTA
DK-TECHNOLOGIES
THOMA
UDT INSTRUMENTS
For more information about the cable specification
required and about the connection, see "Connection Cable
Specifications for Color Temperature Probes" on page 64.
• Copying other data (COPY FROM... menu)
Other data in this monitor, other monitors or "Memory
Stick" is copied.
• Resetting to the default setting (RESTORE
FACTORY DATA menu)
Color temperature data is reset to the default setting.
• Displaying the measured color coordinate and
luminance (ANALYZE menu)
The color coordinate and luminance are measured by
BKM-14L.
Before adjusting the color temperature
We recommend that you perform automatic adjustment
using the AUTO... [A1] menu of the PICTURE ADJ menu.
[B] Adjusting the Color Temperature – COLOR TEMP ADJ Menu
Probe Model Name
BKM-14L (no cable required)
CA-100, CA-100plus
PM 5639
TF6
SLS 9400-FC
33