Electrical Installation-Signature Command System; Features; Battery Installation; System Confi Guration And Setup - Monessen Hearth NB18 Installation And Operating Instructions Manual

NB18/NB24 Gas Log Set

FEATURES

Command Center
•
Easy access function operation and system confi gu-
ration
•
Operation confi rmation/fault diagnostic indications
(LED/Buzzer)
•
ON/OFF/HI/Med/Low operation
•
Optional wall mounting
Control Board
•
Electronic Ignition
•
Pilot Lockout safety feature
•
Electric Power Regeneration from Thermopile to save
battery
•
6-hour Automatic Shut Down Option
•
Standing Pilot/Intermittent pilot Conversion
•
Previous settings Restoration Ability (Memory Off)
•
ON/OFF RF Remote Receiver
•
Optional Transmitter Learn Capability
Transmitter (Options)
(TSTSC is supplied with R-Models) TSTSC
Three Flame Height Settings
Low battery Indication for Transmitter
Child Proof Lock-out
LCD Backlight
Security Codes 10,000
Countdown 6 hr Timer
Standard Thermostatic Control Mode
®
Smart Mode Thermostat

BATTERY INSTALLATION

The Command Center uses four (4) "AA" batteries to
operate the system.
To Install Batteries:
1. Press down the battery door tabs and pull out to remove
battery door.
2. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system is
ready to operate.
5. The batteries should be replaced when the LED indi-
cates low battery or at least once a year.
30
OPERATING INSTRUCTIONS — SIGNATURE COMMAND SYSTEM
TSMSC
X
X
X
X
X
X
X
X
(Auto Flame)
Command Center
RF Receiver
ON/OFF
NG/LP
Conversion
Control
Board
LED
OFF
Figure 48 -
Signature Command System Components
X
X
X
SYSTEM CONFIGURATION/SETUP
X
All System confi guration/setup is done on the Command
X
Center.
X
NOTE: When using On/Off wall switch, the switch must be
--
in the ON position to perform all confi guration set ups at
--
the command center.
COLD CLIMATE OPTION
Choose the Mode That Best Suits Your Needs
The Signature Command System is designed to operate
in either Standing Pilot or Intermittent Pilot mode.
•
The Standing Pilot Mode is best for colder climates
when the pilot must remain on continuously to prevent
condensation and ensure reliable operation.
•
The Intermittent Pilot Mode is ideal for maximum effi -
ciency, igniting the pilot only when needed to start your
fi replace, lowering fuel consumption and reducing your
carbon footprint.
To Thermopile
To Sensor
To Sparker
To Command
Center
To Stepper Motor
To Valve
ON
Master Switch
Battery Door
81D0107