Section 4: Contents Of Hardware Pack - Yard Machines E762F Operator's Manual

SECTION 4: CONTENTS OF HARDWARE PACK

Lay out the hardware according to the illustration for identification purposes. Part numbers are shown in
parentheses. (Hardware pack may contain extra items which are not used on your unit.)
A
ATTACHING THE HANDLES
AND CLUTCH GRIPS
Hex Bolts
5/16-18 x 1-3/4"
(710-3180)
Saddles
(784-5599)
Carriage Bolts
5/16-18 x 1-1/2"
(710-0262)
Hex Nuts
5/16"-18
(712-3010)
Hex Bolts
5/16-18 x 2"
(710-3103)
B
ATTACHING THE SHIFT ROD
AND CONTROL CABLES
Flat Washers
Ferrule
3/8" I.D. x 5/8" O.D.
(711-0677)
(736-0275)
Jam Nuts
#10-24 Thread
(712-0121)
NOTE: The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. If you hit a hard foreign
object or an ice jam, the snow thrower is designed so that the bolts may shear. Two replacement shear bolts and
nuts are provided for your convenience. Store in a safe place until needed.
IMPORTANT: NEVER replace the auger shear bolts with standard hex bolts. Any damage to the auger gearbox or
other components as a result of doing so will NOT be covered by your snow thrower's warranty.
C
Hex Bolts
5/16-18 x 3/4"
(710-3008)
Lock Washers
5/16" I.D.
(736-0119)
Chute Flange
Keepers
(731-0851A)
Cupped Washers
5/16" I.D.
D
(736-0242)
Spacers
(750-1032)
Hex Nut
5/16"-18
Hex Lock Nuts
(712-3010)
5/16"-18
(712-0429)
E
Hair Pin Clip
(714-0104)
F
"Z"-Fitting
(746-0778)
(746-0950)
5
ATTACHING THE CHUTE ASSEMBLY
ATTACHING THE CHUTE CRANK
Flat Washers
3/8" I.D. x 5/8" O.D.
(736-0185)
Cupped Washers
5/16" I.D.
(736-0242)
AUGER SHEAR BOLTS (SPARES)
Shear Bolts
(710-0890A)
Hex Lock Nuts
5/16"-18
(712-0429)
ATTACHING THE TRACK CONTROLS
Track
Controls
Hex Bolts
(710-3015)
1/4-20 x 3/4"
Hex Lock Nuts
1/4"-20
(712-3027)
Hair Pin Clip
(714-0104)