KitchenAid KECC508MBL Technical Education page 23

4. To remove the electronic control board:
a) Remove the user interface board (per-
form step 3).
b) Lift the right side of the user interface
board bracket, and pull the two tabs out
of their chassis slots, then pull the right
bracket tabs out of their chassis mount-
ing slots.
c) Rotate the bracket to the left, discon-
nect wire connector JP08 from the elec-
tronic control board, and remove the
bracket and wire connector assembly.
User Interface Board Bracket
d) Disconnect the following connectors
from the electronic control board (see
the photo at the top of the right column):
3-wire connector at JP12.
Green connector.
White connector.
Red connector.
Blue connector.
Bracket Tab (1 of 2)
Electronic Control
Board Connector
JP08
4-5
Green White Red Blue
Electronic Control Board
JP12
e) At the bottom of the burner box, remove
the four mounting screws from the elec-
tronic control board holder.
Electronic Control Board Screws (4)
f) Lift the electronic control board and its
holder from the unit.
Electronic Control
Board & Holder