NEC VE303 User Manual page 79

Appendices
Warning: To reduce the
risk of personal injury, do
not drop the lamp module
or touch the lamp bulb.
The bulb may shatter
and cause injury if it is
dropped.
Do not break the glass
•
on the lamp module.
Keep finger prints off
the glass surface on the
lamp module. Leaving
finger prints on the glass
surface might cause an
unwanted shadow and
poor picture quality.
• Be sure to tighten the
screws after replacing
the lamp module.
5. Slide and remove the cover. 
Make sure

to align the
positioning
holes over the
positioning
protrusions for
installing the
lamp module.
English ... 72
Positioning holes
Positioning protrusions
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the "POWER OFF"
button on the remote control or the
2. Allow the projector to cool down at least 60 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to loosen the screw on the lamp cover. 
6. Loosen the screw on the lamp module. 
7. Lift the handle. x
8. Pinch the arrow marked positions on the connector housing and
pull the housing upward for removing the connector. y
9. Pull out the lamp module. z
10. Install the new lamp module by reversing the previous steps.
11. After replacing the lamp, turn on the power, and select the MENU
button -> OPTIONS|LAMP SETTINGS -> CLEAR LAMP HOURS
to reset the lamp usage hours. Please see page 61.
2
3
4
5
6
button on the control panel.
1