Table of Contents
Advertisement
SOL202SIP – SOL808SIP - Slate integrated roof kit manual
3
Product features and descriptions
The Dimplex Slate Integrated Roof kit offers a unique solution for mounting solar ther-
mal collectors to the roof of a building. The concept of the product is to make the instal-
lation of the collectors a quick and simple process.
The Slate Integrated Roof Kit can cater for 2m² up to 8m² of collector area and comes
in three variations, 2m² kit, 4m² kit and extension kit.
The product consists of various aluminium flashings and fixings that seal the collector
against the roof covering in an aesthetically pleasing way. The collector is an integral
part of the assembly and forms part of the weather tightness of the roof.
4
Collector connections
Due to its four connections, the collector offers a wide choice of connection options.
Ensure that no part of the collector array or collector in the array is short circuited by
following these instructions.
When planning the collector array, the position of the various connection parts must be
in accordance with the diagrams, also pay attention to the position of the highlighted
sensor pocket position.
Table 8 illustrates the components required to make all the collector connections.
Part No
4.1
Single collector portrait connection
When installing a single collector installation, there is one connection option available.
The sensor must always be installed at the top of the collector and on the connection
where the heat transfer fluid leaves the collector.
Figure 2 illustrates the left hand side connection option that is applicable only to a sin-
gle portrait collector connection.
Image
P01
P02
P03
Table 8: Collector connection components
Description
22mm x 90° elbow
22mm stop end
22mm x 22mm straight compression
SOLAR
Page 12 of 60
R02894-2 01/14
Advertisement
Table of Contents
