Instruments And Controls - Cadillac Escalade 2015 Owner's Manual

Cadillac Escalade Owner Manual (GMNA-Localizing-MidEast-7574628) -
2015 - CRC - 8/27/14
Horn
To sound the horn, press
steering wheel.
Windshield Wiper/Washer
The windshield wiper control is on
the turn signal lever.
The windshield wipers are controlled
by turning the band with
FRONT on it.
1
(High Speed): Fast wipes.
w
(Low Speed): Slow wipes.
INT (Intermittent Wipes): Turn
z
the FRONT band up for more
frequent wipes or down for less
frequent wipes.
OFF: Turns the windshield
wipers off.
a
on the
8
(Mist): For a single wipe, turn
8
to , then release. For several
wipes, hold the band on
Clear ice and snow from the wiper
blades before using them. If frozen
to the windshield, carefully loosen or
thaw them. Damaged wiper blades
should be replaced. See Wiper
Blade Replacement on page 10-25.
Heavy snow or ice can overload the
wiper motor. An internal circuit
breaker to the motor will stop the
motor until it cools down.
z
Wiper Parking
If the ignition is put in OFF while the
wipers are on
they will immediately stop.
z
If FRONT is then moved to
OFF before the driver door is
opened or within 10 minutes, the
wipers will restart and move to the
base of the windshield.

Instruments and Controls

If the ignition is put in OFF while the
wipers are performing wipes due to
windshield washing or Rainsense,
the wipers continue to run until they
reach the base of the windshield.
8
longer.
Rainsense
With Rainsense, a sensor near the
top center of the windshield detects
the amount of water on the
windshield and controls the
frequency of the windshield wiper.
Keep this area of the windshield
clear of debris to allow for best
system performance.
Sensitivity): Turn the
band on the wiper lever to adjust the
sensitivity.
w 1
, , or INT,
Black plate (3,1)
INT (Rainsense Wipe
z
FRONT
5-3