Xj-F10X/Xj-F100W - Casio XJ-V100W User Manual

XJ-F10X/XJ-F100W

 Mercury-free Hybrid Light Source
A CASIO-original laser and LED hybrid light source enables high luminance, low power
consumption, and low running cost. This projector does not use a mercury lamp, making it
environmentally friendly.
 No-wait Projection
A CASIO hybrid light source reaches maximum brightness immediately after power is turned on,
compared with a wait of approximately one minute normally required with a mercury lamp. The light
source will even reach maximum brightness immediately if you turn it back on right after you turn it
off. A mercury lamp requires a longer wait in this case to cool down.
 Quick and simple light adjustment (Instant Light Control)
A simple key operation instantly adjusts light output to one of seven levels.
 Auto light adjustment using a light sensor (Intelligent Light Control)
The projector senses surrounding light levels and adjusts light output automatically as required for
efficient low-power operation. (Requires "Light Sensor" setting to be set to "On".)
 Support for five input sources
Analog RGB, component video (Y·Cb·Cr, Y·Pb·Pr), HDMI, composite video, and S-video input
sources are supported. Two HDMI inputs are provided.
 Vertical Keystone Correction
Manual adjustment to correct for vertical keystoning (distortion of the projected image shape
caused when projecting from below or above the projection surface) and return the projected image
to a rectangular shape.
 Power supply to external equipment
A 5V DC terminal enables power supply to external equipment.
 Temporary blanking of projection without cutting power
Turning off projector power also cuts power being supplied to external equipment. To prevent this,
a [BLANK] key lets you temporarily stop projection without interrupting the power supply.
 16W built-in speaker
Audio from the input source can be output from the projector's built-in speaker.
 Ceiling Mounted and Rear Projection Support
The projector can be configured to project an image of normal orientation even when installed
upside down (for ceiling projection) or when projecting from behind the screen.
 Direct Power On
The projector can be configured to turn on automatically and start projecting as soon as it is
plugged into a power outlet.
 Firmware update and user logo image data transfer
Firmware (software in the projector flash ROM) updates and user logo images can be transferred to
the projector from a computer as required.
8