Reversing The Door - Dometic D15 Operating Manual

D 15, D 50, D 100
8.3

Reversing the door

You can also change the hinge of the door, so that it opens to the left rather
than the right.
Then fit the door handle on the other side, see "Fitting the door handle on
the other side" on page 35.
D 15 and D 50
➤ Change the door as described in fig. 3, page 2 to fig. 7, page 3.
D 100
➤ Change the door as described in fig. 8, page 3 to fig. a, page 3.
Fitting the door handle on the other side
➤ Fit the door handle on the other side as described in fig. b, page 4 to
fig. c, page 4.
8.4 Notes on the electrical connections
A
NOTICE!
Leave the appliance to stand upright for about 2 hours after
transporting, before you connect it to the power supply.
Otherwise this could cause faults in the cooling system.
Observe the following when connecting the appliance:
 Connect this appliance to a separate 15 A circuit.
 Have the receptacle and the circuit checked by a qualified electrician to
ensure that the socket is grounded correctly.
 Check that the voltage specification on the type plate is the same as that
of the power supply.
 If you are using an extension cord, it must be suitable for the values which
correspond to the device, see "Technical data" on page 46.
 Do not use an extension cord or a multiple power socket that can be
switched off with just one switch.
 The cord must rest securely behind the appliance and not be allowed to
lie or hang unprotected.
EN
Setting up and connecting the appliance
35