Toro Groundsmaster 4000-D Service Manual page 143

Removal (Fig. 78)
1. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
2. To prevent contamination of hydraulic system during
manifold removal, thoroughly clean exterior of filter
manifold and fittings.
3. Disconnect hydraulic lines from filter manifold and
put caps or plugs on open hydraulic lines and fittings. La-
bel disconnected hydraulic lines for proper reassembly.
4. Remove filter manifold from the frame using Figure
78 as a guide.
5. If hydraulic fittings are to be removed from manifold,
mark fitting orientation to allow correct assembly. Re-
move fittings from manifold and discard O--rings.
Groundsmaster 4000--D/4010--D
Installation (Fig. 78)
1. If fittings were removed from manifold, lubricate and
place new O--rings onto fittings. Install fittings into man-
ifold openings using marks made during the removal
process to properly orientate fittings. Tighten fittings
(see Hydraulic Fitting Installation in the General Infor-
mation section of this chapter).
2. Install filter manifold to the frame using Figure 78 as
a guide.
3. Remove caps and plugs from fittings and hoses. Us-
ing labels placed during manifold removal, properly con-
nect hydraulic lines to manifold (see Hydraulic Hose and
Tube Installation in the General Information section of
this chapter).
4. Make sure hydraulic tank is full. Add correct oil if nec-
essary before returning machine to service.
Page 4 - - 105 Hydraulic System