Troubleshooting; Specifications; Replacement Parts En19; Fixing The Wall Bracket En19 - Panasonic MX-SS1 Operating Instructions Manual

Troubleshooting

Problem
The appliance does • The power plug is not in the outlet.
not turn on.
« Plug in firmly.
• The quantity of the ingredients are too much.
« Reduce the quantity of the ingredients.
• The ingredients are too large.
« Cut them into smaller pieces.
• Using hard ingredients.
The ingredients are
not blending.
« Remove the hard ingredients.
• Using improper speed. (MX-SS1 only)
« Adjust speed by turning the speed control.
• The blade may be damaged.
« Contact the service centre.
• Using hard ingredients.
« Remove the hard ingredients.
• The motor housing may not be securely attached.
Abnormal noise « Re-attach the motor housing.
occur.
(P. EN8, EN9)
• The chopper lid is not close firmly.
(P. EN9) (MX-SS1 only)
« Re-close the chopper lid.
• The quantity of the ingredients are too much.
« Reduce the quantity of the ingredients.
Abnormal vibration • The ingredients are too large.
occur.
« Cut them into smaller pieces.
• Using hard ingredients.
« Remove the hard ingredients.
• The attachment is not attached properly.
« Re-attach it. (P. EN8, EN9)
The attachment is
not able to attach.
If it is still not able to be attached, contact service
centre.
EN18
Cause and Action
Replacement Parts
Part name
Beaker
Chopper bowl

Specifications

Power supply
Power consumption
Speed control Variable speed control
Blender 2 consecutive cycles of 1 min. ON, then 3 min. OFF
2 consecutive cycles of
Chopper
Operation rating 1 min. ON, then 3 min. OFF
2 consecutive cycles of
Whisk
2 min. ON, then 3 min. OFF
Dimensions Blender
(Motor housing +
Chopper 14.7  14.7  36.9 cm
attachment)
Whisk
(W  D  H) (approx.)
Blender
Mass (Motor housing +
Chopper
attachment) (approx.)
Whisk
Length of the power cord (approx.)
Fixing the wall bracket
Q Fix the wall bracket on the firm wall properly. If it is fix on fragile surface such as
sheetrocks, it may be loose up easily and cause the blender to fall or damage to the wall.
1 Drill two holes (depth of plastic tube's length)
in the wall. (Refer to illustration for dimension.)
2 Hammer two plastic tubes into the holes.
3 Secure the wall bracket on the wall with two
screws.
Part number
AMD02-236
AMD01-236
MX-SS1 MX-GS1
220 - 240 V 50 - 60 Hz
600 W
–
–
–
6.4  7.0  39.7 cm 6.4  7.0  39.7 cm
–
6.0  6.8  45.7 cm –
1.0 kg 1.0 kg
1.2 kg –
1.0 kg –
1.3 m
51 mm
6 mm
EN19