Central Brake Lamp; Changing Wheels - BMW 4 Series Owner's Manual

Mobility
Accessing the lamps
1. Use the screwdriver from the onboard ve‐
hicle tool kit to loosen and completely re‐
move the four screws on the trim.
2. Carefully loosen the trim from the trunk lid,
starting at the edge and working toward
the area around the recessed grips. Make
sure that the trim does not become stuck.
3. Carefully swing out the trim.
Replacing the reversing lamp and inner
brake lamp
1. Loosen the bottom fastener and hold the
lamp holder on the guide rail, arrow 1.
2. Loosen the top fastener, arrow 2, and re‐
move the lamp holder, arrow 3.
3. Press the defective bulb gently into the
socket, turn counterclockwise and remove.
4. Insert the new bulb.
206
Replacing components
Online Edition for Part no. 0140 2 909 827 - VI/13
Installing the bulb holder
1. Slide the bulb holder onto the two guide
pins, arrow 1. Insert the two contacts, ar‐
row 2, into the connections, arrow 3.
2. Press on the bulb holder. Make sure that
the two exterior fasteners latch into place.
3. Swing the trim back onto the trunk lid and
secure.
Tail lamp, license plate lamp and

central brake lamp

Follow the general instructions on lamps and
bulbs, refer to page 198.
These lamps are made using LED technology.
Contact your service center in the event of a
malfunction.

Changing wheels

Hints
The vehicle equipment does not include a
spare tire.
When using run-flat tires or tire sealants, a tire
does not need to be changed immediately in
the event of pressure loss due to a flat tire.
The tools for changing wheels are available as
accessories from your service center.