Minimum clearances CLASSIC FF A clearance of 533mm (21") MUST be available at the front of the ( Propane Gas Models Only) boiler for servicing. The minimum clearances given below MUST be complied with in order to maintain the safe running of the boiler and to facilitate Classic G.C.
1 BOILER CONTROLS View inside boiler controls area LEGEND A Sightglass B Thermostat knob C Mains on/off switch D Gas service cock (shown in the OPEN position) E Overheat thermostat reset button Escape of gas Frost protection If no frost protection is provided and frost is likely during a short Should a gas leak be suspected contact your local gas supplier absence from home, leave the heating controls at a reduced without delay.
Page 4
Do not use the installation until it has been checked by a place. CORGI registered installer or in IE a competent person. Caradon Ideal Limited. is a member of the Benchmark initiative and fully supports the aims of the programme. Benchmark has been introduced to improve the standards of installation and...