Door And Drawer Removal - Kenmore TRIO 596.76572600 Use & Care Manual

Leveling
To enhance the appearance and maintain performance,
the refrigerator should be leveled per instructions
below.
To protect property and refrigerator from
damage, observe the following:
* Protect vinyl or other flooring with cardboard, rugs,
or other protective material.
• Do not use power tools when performing leveling
procedure.
Notes:
• Complete any required door reversal, panel
installation and/or a water supply connection
before leveling.
• Some models only have adjustment screws CA:).
Materials Needed:
• _" hex head driver
• Carpenter's level
1. Remove toe grille.
• Grasp firmly and pull
outward to unclip.
2. Using hex head driver, turn the
front adjustment screws CA:) on each side to raise
or lower the front of the refrigerator (see
illustration below).
3_
Using the hex head driver, turn each of these
adjustment screws I:B:) to raise or lower the rear of
the refrigerator.
4. Using a carpenter's level, make sure front of
refrigerator is '/4" (6 ram) or approximately '/2bubble
higher than back of refrigerator and that the
refrigerator is level from side to side.
5. Turn stabilizing legs CO:) clockwise until firmly
against floor.
6. Turn adjustment screws CA:) counterclockwise until
the full weight of the refrigerator rests on the
stabilizing legs.
7. Replace the toe grille.
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
Door and Drawer Removal
Some installations require door/drawer removal to
transport the refrigerator to its final location.
To avoid electrical shock which can cause
severe personal injury or death, observe the
following:
Disconnect power to refrigerator before removing
doors or drawer. Connect power only after
replacing doors or drawer.
To avoid damage to walls and flooring, protect vinyl
or other flooring with cardboard, rugs or other
protective material.
Materials Needed:
* _" hex head driver
* Phillips screwdriver
.3A,, hex head driver
1. Unplug power cord from power source.
2. Remove toe grille.
3. Remove top hinge cover from
refrigerator door by removing Phillips
screw and retain screw and cover for
later use.
4_
Unscrew _/,6"hex head screws from
top hinge to remove hinge and
retain all screws for later use.
5_
Lift right side refrigerator door from = =
center hinge pin. Remove door
closure from center hinge pin on the
right side and retain for later use.