Normal Mode; Phase Mode - Hitachi 51SWX20B Training

DP-2X CHASSIS DCU CROSSHATCH PHASE ADJUSTMENT
Adjustment Preparation:
•
Cut Off adjustment should
be finished.
•
Video Control: Brightness
90%, Contrast Max.
Adjustment Procedure:

NORMAL MODE

1) Receive any NTSC signal.
2) Screen Format is Normal
3) Press the SERVICE
ONLY switch on the De-
flection/Power PWB to
enter DCAM.
4) Press the A/V NET key
on the Remote, Green
Cross hatch appears.
5) Then press the EXIT key.
(This is the Phase
4 and 6 keys on Remote
2 and 5 keys on Remote
Cursor Left and Right on Remote
Cursor Up and Down on Remote
adjustment mode).
6) Adjust data value using
the keys indicated in the
chart, until the data
matches the values indi-
cated in the chart.
Exiting Adjustment Mode:
7) Press AV NET key on
remote control.
8) Press PIP MODE key
TWICE to store the
information.
9) When Green dots are
displayed, press the
MUTE key twice to re-
turn to DCAM grid.

PHASE MODE

ADJUST USING
*DCA stands for (Digital
Convergence Adjustment)
Display Format
NORMAL
Address
Data
Value
PH-H CD
PH-V 04
CR-H 35
CR-V 0A
PAGE 07-05