Makita BDF456 Technical Information page 7

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-2. Gear assembly and Motor section (cont.)
ASSEMBLING
(5) Engage the notch of Yoke unit with the projection inside of Housing (L) when mounting the assembly of Gear section
and Motor section to Housing (L). (Fig. 12)
Fig. 12
Engage the notch of Yoke unit with the projection inside of Housing (L).
projection for fitting
to the notch
(6) Adjust the assembly of Motor section and the Gear section to the correct position in Housing (L)
so as to assemble Housing (R) to Housing (L) smoothly and exactly. (Fig. 13)
Fig. 13
edge of
Housing (L)
Housing (L)
The flat portion of Brush holder must be at
exactly 90 degrees to the edge of Housing (L).
Housing (L)
90 degrees
flat portion of
Brush holder
complete
Brush holder
complete
notch
Yoke unit must be mounted
within these ribs.
P 7/10
Yoke unit
This rib must be fit in
the groove of Change ring.