Inspection Steps - Yamaha wr250f Owner's Service Manual

THROTTLE POSITION SENSOR SYSTEM

INSPECTION STEPS

If the throttle position sensor will not operate, use the following inspection steps.
Check entire ignition
system for connection.
Check throttle position
sensor.
*Check CDI magneto.
Check CDI unit.
*marked: Refer to "IGNITION SYSTEM" section.
NOTE:
Remove the following parts before inspection.
1) Seat
2) Fuel tank
Use the following special tools in this inspection.
Pocket tester:
YU-3112-C/90890-03112
THROTTLE POSITION SENSOR SYSTEM
OK
Throttle posi-
tion sensor coil
OK
Charging coil
OK
Throttle posi-
tion sensor
input voltage
No good
No good
No good
No good
Inductive tachometer:
YU-08036-B
Engine tachometer:
90890-03113
6 - 7
– +
ELEC
Repair or replace.
Replace.
Replace.
Replace.