Tensioning The Chain; Checking Chain Tension; Fuel - Stihl MS 381 Instruction Manual

Tensioning the Chain

1
Retensioning during cutting work:
Shut off the engine.
N
Loosen the nuts.
N
Hold the bar nose up.
N
Use a screwdriver to turn the
N
tensioning screw (1) clockwise until
the chain fits snugly against the
underside of the bar.
While still holding the bar nose up,
N
tighten down the nuts firmly.
Go to "Checking Chain Tension".
N
A new chain has to be retensioned more
often than one that has been in use for
some time.
Check chain tension frequently –
N
see chapter on "Operating
Instructions".
MS 381

Checking Chain Tension

Shut off the engine.
N
Wear work gloves to protect your
N
hands.
The chain must fit snugly against
N
the underside of the bar and it must
still be possible to pull the chain
along the bar by hand.
If necessary, retension the chain.
N
A new chain has to be retensioned more
often than one that has been in use for
some time.
Check chain tension frequently –
N
see chapter on "Operating
Instructions".

Fuel

Your engine requires a mixture of
gasoline and engine oil.
WARNING
For health reasons, avoid direct skin
contact with gasoline and avoid inhaling
gasoline vapor.
STIHL MotoMix
STIHL recommends the use of STIHL
MotoMix. This ready-to-use fuel mix
contains no benzol or lead, has a high
octane rating and ensures that you
always use the right mix ratio.
STIHL MotoMix uses STIHL HP Ultra
two-stroke engine oil for an extra long
engine life.
MotoMix is not available in all markets.
Mixing Fuel
NOTICE
Unsuitable fuels or lubricants or mix
ratios other than those specified may
result in serious damage to the engine.
Poor quality gasoline or engine oil may
damage the engine, sealing rings, hoses
and the fuel tank.
Gasoline
Use only high-quality brand-name
gasoline with a minimum octane rating
of 90 – leaded or unleaded.
English
71