Table of Contents
Advertisement
2
Verifying Your TV, DVD, VCR and AUX Mode Codes
You can verify the accepted programming codes for each mode by following these
steps.
1.
Press the TV key for at least three seconds—until the LED blinks.
2.
Press the "INFO" key.
3.
The LED will blink, indicating the code of your TV in the following
sequence. For example, if your TV code is for a Tandy brand TV (code 1005)
the blink pattern will be:
- Pause>long blink "1;"
- Pause>short blink "0;"
- Pause>short blink "0;"
- Pause>long blink, long blink, long blink, long blink, long blink "5."
A zero in the code will always be represented by a short blink.
Volume Control Crossover
Your remote control unit is programmed from the factory to control the volume of
your television set when you are using the remote control in the TV mode. The
AUX mode can also be programmed to control the audio from the TV or Audio
device. To program your remote control for this function:
•
Enter the programming mode using the AUX mode key.
•
While the AUX mode key is flashing, press and release the AUX mode or TV
mode key (depending on which device you want remote volume and mute
control).
•
The AUX mode key will light as you press and release the programming mode
key, flash three times rapidly and extinguish.
•
The remote control will now control the volume of the SAT device when in the
AUX mode.
If You Have More Than One Satellite Receiver
If you have more than one receiver, you may want to prevent the remote controls
from affecting the other receivers. To prevent this kind of interference, you must
"pair" each remote control with one receiver. In order to do this, you will have to
assign a new "address" to each pair of remote controls and receivers so that each
pair functions independently of the others.
14
Advertisement
Table of Contents
