Panasonic DMP-B100 Operating Instructions Manual page 37

Sound
No sound from the unit's speaker.
The speaker is off if headphones are connected.
Turn up the volume. ( 14)
Cannot hear the desired audio type.
Press [AUDIO] to select the audio. (
Cannot switch audio.
There are discs for which audio cannot be changed because
of how the disc was created.
When connecting an amplifier/receiver using an HDMI cable,
you cannot switch the audio if "Dolby D/Dolby D +/Dolby
TrueHD" or "DTS/DTS-HD" is set to "Bitstream". Set "Dolby
D/Dolby D +/Dolby TrueHD" or "DTS/DTS-HD" to "PCM".
( 28)
Connection
The images from this unit do not appear on the
television.
Picture is distorted.
Make sure that the television is connected to HDMI AV OUT
terminal on this unit. ( 24)
Make sure that the television's input setting (e.g., VIDEO 1) is
correct.
When "24p Output" is set to "On", HDMI authentication takes
place where 24p images switch to other images, and a black
screen is displayed. ( 29)
When "24p Output" is set to "On", jittering may occur while
playing DVD-Video other than 24p images. In this case, turn
"24p Output" to "Off". ( 29)
An incorrect resolution is selected in "HDMI Resolution",
when the television is connected to HDMI AV OUT terminal.
Set the item again.
Picture may not be seen when more than 4 devices are
connected with HDMI cables. Reduce the number of
connected devices.
Video is not output in high definition.
Confirm that the "HDMI Resolution" in the Setup menu is set
properly. ( 29)
Audio is not output in bitstream.
The 4:3 aspect ratio picture expands left and right.
Screen size is wrong.
17)
No sound from other speakers.
Cannot hear the desired audio type.
Cannot switch audio.
Music on an SD card cannot be played.
The contents of the card cannot be read.
Dolby Digital Plus, Dolby TrueHD, and DTS-HD audio are not
output in bitstream. To output the bitstream, select "Restore
Default Settings" to restore the factory presets and make
proper settings.
Use the television to change the aspect. Refer to your
television's operating instructions.
When using an HDMI cable, change "TV Aspect" type to "4:3
Pan & Scan". ( 29)
Check all connections and settings. (
Audio may not be heard when more than 4 devices are
connected with HDMI cables. Reduce the number of
connected devices.
When connecting an amplifier/receiver using an HDMI cable,
you cannot switch the audio if "Dolby D/Dolby D +/Dolby
TrueHD" or "DTS/DTS-HD" is set to "Bitstream". Set "Dolby
D/Dolby D +/Dolby TrueHD" or "DTS/DTS-HD" to "PCM".
( 28)
Card
Data that can be played from an SD card are AVCHD,
MPEG2 and JPEG data. (
The card is not compatible or the contents on the card may
be damaged. ( 7)
Turn off and then turn on the unit again.
24)
7)
VQT2K11
(ENG)
37