Jensen JMC-1250 User Manual page 16

CONTINUOUS PLAYBACK OF TWO CASSETTES
1.) Insert a pre-recorded tape into both cassette compartments with the tape you
want to play first in DECK 2.
2.) Press the Play
3.) Press the Pause
4.) When the tape in DECK 2 ends, it stops and the Pause
release automatically to begin playback on DECK 1.
NOTE: Continuous playback will not function if you play the tape in DECK 1 first.
RECORDING
This cassette recorder features an Automatic Recording Volume Level Control
System that prevents overloaded or distorted recordings. You can change the
volume level as often as you like during the recording process. It will not have any
effect on the volume level of the recording itself.
Insert a good quality blank tape into DECK 1 with the exposed tape facing down
and the full reel on the left side. Close DECK 1 door.
A. RECORDING FROM TAPE (DECK 2 TO DECK 1)
This unit enables you to duplicate a pre-recorded tape to another tape. It is
performed only one way from deck 2 (playback) to deck 1 (recording).
DUBBING AT NORMAL SPEED
Press the TAPE BUTTON (#26) to enter Tape Mode.
Inset a pre-recorded cassette into deck 2 and a blank cassette tape into deck 1.
Press the " PAUSE " key and then press the " RECORD " and " PLAY " key at
deck A.
Press the " PLAY " key to start playback at deck 2 and then release " PAUSE "
key at deck 1 to start dubbing.
Press " PAUSE " key at deck 1 and " STOP " key at deck 2 when finish.
DUBBING AT HIGH SPEED
This unit is equipped with a high speed dubbing system that saves dubbing time by
2/3 when compare to normal speed.
Push the FM MODE/
and then follow the same procedures as covered in "dubbing at normal speed".
When dubbing a pre-recorded cassette tape at high speed, a chattering sound is
being heard. to avoid this, set the volume control to a minimum level.
Do not push the FM MODE/
dubbing, this will vary the speed of recording and may be damage the cassette
tape.
B. RECORDING FROM THE RADIO
Press the
TUNER/BAND BUTTON
Tune to the desired station and insert a blank cassette tape in deck 1.
Press the "RECORD" & "PLAY" button to start recording.
Press the "PAUSE" keys and then the "STOP/EJECT" key when finish.
button on DECK 2 to begin playback.
button and then Play
DUBBING SPEED SELECTOR
DUBBING SPEED SELECTOR
(#25) to enter radio mode
E-15
button of DECK 1.
key of DECK 1 will
BUTTON #6) to " HI " position
BUTTON #6) during