Advertisement
TM
PSH23NGP – GE Profile Arctica
Collar Trim Installation
An enclosure is required to match up to the trim, see Typical
Installation. To obtain the most integrated look, the cabinet or soffit
above the refrigerator should extend out to the same depth as the
side panels. The refrigerator opening must have minimum dimensions
of 70-1/4" high x 36-1/8" wide x 24-1/2" deep as shown at right. If
there is an overhead cabinet, allow 1" for cabinet door clearance
with the top trim piece so the cabinet doors can be opened without
hitting the top trim. If 1/2" side panels are used, then side trim and
panel will be even. If 3/4" side panels are used, then some of the
side panel will extend beyond the trim and must be finished.
Typical Installation
Shaded areas represent front surfaces of
side panels and overhead cabinet or soffit that contacts trim.
Specification Created 2/03
22.6 Cu. Ft. CustomStyle
™
1/2" minimum
*The rough-in dimension of 70-1/4" is minimum and is measured from the
finished floor to top of opening (or the underside of the overhead cabinets).
For Models with Trim Kit: If frameless style cabinets are planned for above the
refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to
height of opening to allow additional clearance between cabinet doors and
top of refrigerator trim when cabinet doors are in open position.
Total volume and shelf
area are calculated by the
Association of Home
Appliance Manufacturers'
R
standards.
Side-by-Side Refrigerator with Dispenser
™
70-1/4"*
24-1/2"*
36-1/8"
Listed by
Underwriters
®
As an ENERGY STAR
Partner,
Laboratories
GE has determined that this product
®
meets the ENERGY STAR
guidelines for energy efficiency.
3/4" Cabinet
Refrigerator
Side Panel
Case
1/2" Cabinet
Side Panel
Magnetic
Tape
Door Gasket
Side Trim
Side trim must be installed
flush with the gasket contact
surface on the case.
Cabinet
Overhead
Door
Cabinet
1"
Case
Top Trim
IMPORTANT: Before finalizing specifications for your
GE Profile CustomStyle Refrigerator, please NOTE:
• A minimum of 36-1/8" is required for refrigerator
installation with collar
• Be sure to allow for 1/2" or 3/4" side panels in
addition to the 36-1/8" minimum
For answers to your Monogram,
®
GE Profile
GE appliance questions, visit our website at
R
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.
™
or
Advertisement
