Installation - Hitachi CPX960WA User Manual

Installation

Typical LCD Projector and Screen Installation
Use the diagram below as reference to determine the screen size and projection distnace.
Top view
Screen
Screen size (inches)
Minimum
40
60
80
100
120
150
200
Using the adjusters
Use the adjusters on the bottom to adjust the projection angle.
Front view
Adjuster
1. Lift up the projector and release the adjuster lock.
2. After adjusting the projection angle, firmly lock the adjusters.
3. Rotate the adjusters for fine adjustment.
Caution
• Do not release the locks unless the projector is being held; otherwise, the projector could
overturn or the fingers could get caught and cause personal injury.
• Do not force the adjusters to rotate. This could damage the adjusters or cause the lock to fail.
• Lock the adjusters firmly. If the lock is difficult to operate, change the angle slightly and try again.
12
a
a (inches)
b (inches)
Maximum
55 73 1
85 114 2
114 151 2
144 191 3
176 231 3
220 282 4
291 386 6
Side view
Lens center
b
a
a. Distance from the LCD projector to the screen
b. Distance from the lens center to the bottom of
the screen (a,b : +/-10%).
Caution
The LCD projector should normally be used
level (the legs can point upward).
Positioning the projector sideways, or with the
lens pointing upward or downward can cause the
internal temperature to rise, which could result in
a malfunction.
The projection distances shown in the diagram to
the left are for full size (1,024 x 768 dots).
Side view
Variable within the range of approximately 0° - 9°