GENERAL INFORMATION
STRUT ASSEMBLY
Nut
15 ft. lbs.
(21 Nm)
Washer
Spacer Rubber
Upper Pivot Ball
Washer
Bolt
Spacer
Lower Pivot Ball
Spring Retainer
Spring
NOTE: Be sure steel insert notch (1) and strut casting notch are lined up and provide a channel for the
magnetic coil wires to lie in. If insert and strut do not match, strut replacement will be necessary.
Grease fitting (2) location. Check lubrication guide for recommended service intervals.
Specified pole gap is 0-.001" (0-.0254mm)
Strut Bumper
Spring Retainer
Clamp
15 ft. lbs.
(21 Nm)
Washer
Hub Coil
Use the Seal Sleeve Installation
Tool (PN 2871199)
18 ft. lbs.
(25 Nm)
Wire retainer
1
2
5.13