Smart Loader; In Reference Tv; In Tv To Be Cloned - Sharp LC-40LE540E Service Manual

LC-40LE540
LC-46LE540
8. Public Mode (Hotel mode) ( continued )
10. INPUT MODE FIXED [VARIABLE → FIXED]
"FIXED" has been selected, any channels and input modes other than those selected at the start mode cannot
be picked up.
11. INPUT TV MODE PROGRAM NUMBER [1-999]
When any other item than "NORMAL", i.e. number, has been selected, and "INPUT MODE START" option is
set to "TV", the sets will start in the selected service / program number at the next power-on.
12. RC PATH THROUGH [ON ↔ OFF]
When ON and RS-232 circuitry is really assembled , in pin #9 of RS-232 socket appears a feedback of
the remote signal (3.3v logic type).
13. HOTEL MODE [ON ↔ OFF]
If ON has been selected the HOTEL MODE is activated.
14. RESET
Cancel all Public Mode settings. (It returns to the factory settings)
15. COMMIT
Press OK to select this item, or press cursor RIGHT / LEFT keys on the remote control to apply the change.
If "YES" is selected the change will be stored and the TV set will be reset.

9. SMART LOADER

Description.
The Smartloader is a function implemented in the service software of SEES designed L540 series intended to easily
replicate the user settings of one TV into another. These settings include (but not restricted to): picture and audio, tun-
ing set-up, language and country selection, PIN, child locked programs... Factory adjustments are not copied as they
are different for every TV.
The Smartloader makes possible the user data to be stored in a memory device connected to the USB terminal of the
TV that is used as reference and later load those data into other TVs by using their respective USB terminal.
How it works.

In reference TV:

1. Insert a memory device in the USB slot.
2. Enter in service mode, select Factory Menu and SMARTLOADER option.
3. Select "Save settings to USB" and press the RIGHT cursor in the remote control.
4. Wait until "OK" is displayed, the fi le has been successfully created in the root directory of the memory device.
In case of error, an explanation message is shown.

In TV to be cloned:

1. Insert a memory device with a fi le in it obtained following the above procedure.
2. Enter in service mode, select Factory Menu and SMARTLOADER option.
3. Select "Load settings from USB" and press the RIGHT button in the remote control.
4. After some seconds, "OK, reboot TV set" is displayed. In case of error, an explanation message is shown.
5. As indicated, reboot the TV to load the new settings.
Very important: All the TVs must have the same software version and hardware.
34