Help with minor problems
Fault displays
Text in display field
and signal emitted
F:16
F:17
F:17
F:18
F:18
If repairs are needed, and assuming that you cannot
eliminate the fault yourself with the aid the following
table:
q Turn the programme selector to Off.
q Disconnect the appliance from the mains.
q Turn off the tap.
q Call customer service, see page 54.
Call customer service, see page 54.
Call customer service, see page 54.
d
Risk of electric shock!
Risk of electric shock!
Risk of electric shock!
Repairs may be carried out by customer service or
Repairs may be carried out by customer service or
Repairs may be carried out by customer service or
authorised technicians only.
authorised technicians only.
authorised technicians only.
Possible cause
Door not closed properly.
Door not closed properly.
Door not closed properly.
Tap not turned on.
Tap not turned on.
Tap not turned on.
Inlet hose kinked or pinched.
Inlet hose kinked or pinched.
Inlet hose kinked or pinched.
Filter blocked in water inlet hose.
Filter blocked in water inlet hose.
Filter blocked in water inlet hose.
Water pressure too low.
Loose debris is blocking the pump.
Drainage pipe and/or drainage hose
blocked.
There is too much residual water in
the drum when drying.
Remedial action
Check whether laundry is trapped in
door;
Close the washer dryer door.
Turn the tap on.
Eliminate cause.
Clean filter, see page 47.
Eliminate cause.
Clean the pump, see page 45.
Clean drainage pipe and/or drainage
hose.
Stop the drying programme, select
the Spin B" programme before
drying.
49