Advertisement
3
PREPARING THE RADIO 遙控器準備工作
a
a. Install the antenna into transmitter.
b. Check the frequency printed on the transmitter crystal.
c. Check the frequency printed on the receiver crystal, and make sure it matches with the transmitter crystal. Make sure no one will
operate on the same frequency when you are. When there is a radio glitch, it will most likely be caused by improper crystal, damaged
crystal, or people operating on the same frequency.
a. 裝上發射機天線。
b. 檢查發射機頻率。
c. 檢查接收機晶體頻率，確認發射機與接收機頻率是否相同。大部份搖控器會失靈可能都是頻率造成或附近有人使用相同的操控頻
率。並確認所有的電子接線都牢固，且依序連結在接收機的連結插孔，確認完畢後，將接收機放回接收機盒並且安全的固定好。將
多出的線路以束帶纏繞整理並固定於適當地方，線路安排應避免靠近轉動的零件以免線路受損。
4
RADIO BATTERY INSTALLATION 遙控器電池安裝
a
a. Install 8 AA-size alkaline batteries into transmitter.
b. Install the power pack (stick type battery pack shown in the picture) and connect to the ESC. (6607)
Caution: Check all the wiring and connections before you connect the speed control to a drive battery. Incorrect polarity
will wreck your speed control.
a. 安裝發射機電池或電池包。
b. 將開關座固定於接收機旁(如圖示)。將模型專用7.2V條狀充電電池裝入底板上並以R型固定插銷固定電池上蓋，連接電池條開關與
速控器。
注意！如使用自行焊接之充電電池請注意電池與速控器接線之正負極位置（反裝電極將造或電池短路或速控器之損壞）。
5
RADIO OPERATION 遙控器操作
a
a. When turning radio on, first turn on the transmitter.
b. Then, turn on the ESC. When turning off, first turn the ESC off, then the transmitter off.(6667)
c. To reverse the functions of servos, use the small, white servo reverse switches located on side of the pistol transmitter (or the
inset servo reverse switches located at the bottom of the stick transmitter). To trim the servos on pistol transmitter, use the trim
switches on side of the steering wheel (the ST. trims steering, and the TH trims throttle/brake). On a stick transmitter, the trim
levers are located accordingly around the sticks.
Caution: Do not run flat the battery of your transmitter in case of losing control of the car. For more details, please check
the transmitter instruction manual.
a. 為避免車子失控暴衝，先開啟發射機電源。
b. 接著開啟速控器電源。電源的關閉則是相反的順序，先關速控器電源，再關發射機電源。
c. 伺服機的正逆轉開關，槍型發射機在左側
(桿型發射機在底部)
。更詳細的使用說明，請參考遙控器使用說明。
注意!
操作前請先確認電池處於充飽電之狀態，以免發生失控之狀況。其他注意事項請參考發射機說明書。
b
b
b
b
c
c
Advertisement
