Razor PowerCore E90 Owner's Manual page 8

REPAIR AND MAINTENANCE
q Rear Wheel/Hub Motor/Battery Replacement Cont'd
Tool Required: Phillips Screwdriver and Two (2) 13 mm Wrenches
Black
5
Using a pointed object carefully depress the
tabs on the metal pins inside of the motor wire
connector and remove the wires. Carefully pull
wires out from battery tray.
7
Using a 13 mm wrench, loosen the outside
locknut (14-6). Use a 13 mm wrench to prevent the
inside nut (14-3) from turning.
Remove wheel/hub motor.
q Battery Care and Disposal
Do not store in freezing or below freezing temperatures. To properly maintain your battery and ensure maximum battery
life, carefully read the "Charging the Battery" section on page 3 of this owner's manual.
CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED.
Pb
Pb
Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an
environmentally safe manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not
dispose of a lead-acid battery in your regular household trash. The incineration, land filling or mixing of sealed lead-
acid batteries with household trash is prohibited by law in most areas. Return exhausted batteries to a federal or state
approved lead-acid battery recycler or a local seller of automotive batteries. If you live in Florida or Minnesota, it is
prohibited by law to throw away lead-acid batteries in the municipal waste stream.
q Charger
The charger supplied with the electric scooter should be
regularly examined for damage to the cord, plug,
enclosure and other parts and in the event of such
damage, the product must not be charged until it has
been repaired or replaced.
Use ONLY with the recommended charger.
q Wheels
Wheels and drive system are subject to normal wear
and tear. It is the responsibility of the user to periodically
inspect wheels for excess wear and replace hub motor
components as required.
Red
6
Using a Phillips screwdriver remove the two (2)
screws that attach the motor housing
to the frame.
A
8
To install the replacement wheel/hub motor,
reverse steps 1 through 7.
q Replacement Parts
The most frequently requested replacement parts are
available for purchase at some Razor retail partners. For
the complete selection of replacement parts visit
shop.razor.com.
q Repair Centers
For a list of authorized Razor repair centers:
• Check online at www.razor.com.
• Additional Customer Service contact information is
listed on the back of this manual.
C
B
6
Note: When re-inserting the motor
wires into the connector, make sure
the red wire connects to the blue
wire and the black wire connects to
the brown wire.
Note:
Motor Control Module
Red Blue
1
Black 1 Brown
WARNING: If a battery
leak develops, avoid contact with
the leaking acid and place the
damaged battery in a plastic bag.
Refer to the disposal instructions
at left. If acid comes into contact
with skin or eyes, flush with cool
water for at least 15 minutes and
contact a physician.
WARNING: Battery
posts, terminals and related
accessories contain lead and
lead compounds. Wash your
hands after handling.