Product Data Sheets - Whirlpool 2210718 Use & Care Manual

Base Grille Water Filtration System Model WF-NL300/NL300
Capacity: 300 Gallons (1136 Liters)
Service Flow Rate: 0.5 GPM (1.89 L/min.) @ 60 psi.
Substance
Reduction
Chlorine, Taste/Odor
Contaminant U.S. EPA
Reduction MCL
Performance**
Lead: @ pH 6.5 0.015 mg/L
Lead: @ pH 8.5 0.015 mg/L
Base Grille Water Filtration System Model WF-L500/L500
Capacity: 500 Gallons (1893 Liters)
Service Flow Rate: 0.5 GPM (1.89 L/min.) @ 60 psi.
Substance
Reduction
Chlorine, Taste/Odor
Contaminant U.S. EPA
Reduction MCL
Performance**
Lead: @ pH 6.5 0.015 mg/L
Lead: @ pH 8.5 0.015 mg/L
It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
Model WF-NL300 Change cartridge at least every 6-9
months. Use replacement cartridge NL 300, part# 4392857.
2000 Suggested retail price of $29.95 U.S.A./$39.95 Canada.
Model WF-L500 The filter monitor system measures the
amount of water that passes through the filter and alerts you
to replace the filter. When 90% of the filter's rated life is used,
the filter indicator light changes from green to yellow. When
100% of the filter's rated life is used, the filter indicator light
changes from yellow to red, and it is recommended that you
replace the filter. Use replacement cartridge L500, part#
4392857. 2000 Suggested retail price of $29.95 U.S.A./
$39.95 Canada.
The product is for cold water use only.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
*
Test requirement is 0.15 mg/L ± 10%.
**
These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
® NSF is a registered trademark of NSF International.
26

PRODUCT DATA SHEETS

Tested and certified by NSF International against ANSI/NSF
Standard 42 for the reduction of Chlorine (Class I) Taste and Odor
and against ANSI/NSF Standard 53 for the reduction of Lead.
Average Maximum
Influent Effluent
2.0 mg/L N/A
Average Maximum
Influent Effluent
0.16 mg/L* 0.007 mg/L
0.14 mg/L* 0.012 mg/L
Tested and certified by NSF International against ANSI/NSF
Standard 42 for the reduction of Chlorine (Class I) Taste and Odor
and against ANSI/NSF Standard 53 for the reduction of Lead.
Average Maximum
Influent Effluent
2.0 mg/L N/A
Average Maximum
Influent Effluent
0.16 mg/L* 0.007 mg/L
0.14 mg/L* 0.012 mg/L
Average Minimum %
Effluent Reduction
0.1 mg/L N/A
Average Minimum%
Effluent Reduction
0.005 mg/L 95%
0.008 mg/L 91%
Average Minimum %
Effluent Reduction
0.1 mg/L N/A
Average Minimum%
Effluent Reduction
0.005 mg/L 95%
0.008 mg/L 91%
Refer to the "Assistance or Service" section for the
Manufacturer's name, address and telephone number.
Refer to the "Warranty" section for the Manufacturer's limited
warranty.
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Average % NSF Test
Reduction Number
95% 981788
Average% NSF Test
Reduction Number
97% 976115
94% 976116
Average % NSF Test
Reduction Number
95% 981788
Average% NSF Test
Reduction Number
97% 976115
94% 976116
City or Well
30 - 120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8° C)